#Virtualbox network settings for kali mac#

:~ $ Assign IP Address for the network (eth0 or wlan0)Įth0 is the number of a wired network interface card. if you want to assign IP address for wireless adapter replace eth0 by wlan0. #ifconfig eth0 up :~ $sudo ifconfig eth0 down :~ $udo ifconfig You can use the following syntax to enable and disable network interface cards. You can use Ifconfig command followed by up option and interface name to start the network interface and for stopping it use the down option. You have more than 1 interface, and you want to use only 1 adapter, then disable other adapters. Sometimes you find that network interface is not responding properly, you will have to enable and disable.

If you didn’t create a normal user in Kali Linux then you are using the system by the root user. You can run this command as a normal user, sudo user, or root user.

#Virtualbox network settings for kali mac#

You have seen the result of ifconfig command, You can see assigned IP address, MAC address, Netmask, for IPv4, etc. TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 :~ $ : ~$ sudo ifconfig -a TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0